All diagnostic cases

Ford Focus III

Overcharging disappears after a few gear changes

On a Focus 2.0 turbo, the driver reports a loss of boost after changing gear. Faults P0034 and P0035 reappear after replacing the solenoid valve.

What changed after the intervention

After replacing the solenoid valve and clearing the codes, boost returns briefly. It disappears again after a few gear changes and the engine light comes back on. This temporary return does not validate the repair.

Two indications on the circuit

P0034 and P0035 describe a low signal and a high signal of the bypass valve control circuit, respectively. They may have been recorded at different times. Preserving their statuses and their appearance conditions allows events to be compared.

Which would make it possible to decide between the tracks

Confirm the assembly of this American version before choosing the electrical diagram or part number. Examine the plug and harness handled during replacement. Then compare the expected command and the signal measured according to the Ford procedure.

The solenoid valve was replaced according to the driver. The cause of the defect's return and the final result remain unknown.